E-CATALOGSITEMAPENGLISH
PRODUCTS LIST
HDPE Blown Film Machine.
Features
Normally when producing film rolls for T-shirt bag conversion which ranges from 6"~15"(INCH) in width, it is difficult to achieve higher output by using a bigger extruder for such small film width unless the blown film extruder is equipped with an internal bubble cooling. The Twin head blown film machine for T shirt bag offers an economic alternative and has a much faster return on investment comparing to a blown film machine installed with IBC system (Optional). In Twin head blown film machines for T shirt bags, one die head can reach much higher output with a bigger Extrusion when producing smaller width film, especially effective for T-shirt bag makers who are looking for a machine with higher output but lower cost. Compared to extruders with single die head, the Twin head blown film machine for T shirt bags can achieve higher production capacity when producing film roll that is small in width, as the high extrusion output is dispersed into two separate channels of the die heads instead of one. DIPO designs and customizes this Twin head blown film machine for T shirt bags with different screw diameters and roller width, depending on the customers’ requirement. The Twin head blown film machine for T shirt bag also allows producers to switch between HDPE and LDPE production as well as producing different film width on the same machine on each winder simultaneously. A special screw design is used to provide good mixing and stable output for both HDPE and LDPE material. Bimetallic treatment is applied to process a higher percentage of recycled material and CaCO3 compound. DIPO uses Siemens/ABB energy saving motors for the Twin head blown film machine for T shirt bags, reducing energy consumption by up to 5%.

Blown film machine for HDPE. 


Model DP-HDPE-55SS
SPECIFICATION
SUITABLE MATERIAL HDPE
FILM THICKNESS 0.08~0.10MM
FILM WIDTH 6"~15"(INCH)
FILM OUTPUT 35~70KGS/HR
AUTO THEMO CONTROL 10 ZONE
EXTRUDER
SCREW DIAMETER 55MM
SCREW L/D 32:1
BARREL COOLING FAN 1/8 HP x 3
SCREW SPPE 25~100(PRM)
DRIVING MOTOR 30 HP(INVERTER)
AIR RING 2 SETS
GEAR BOX x 3 AXIS SL 30
CERAMIC HEATING 1 SET
EXTRUDER
CERANIC HEATING 1 SET
DIE
DIE DIAMETER 60MM x 2
COOLING BLOWER 5PH x 2(INVERTER)
TAKE UP DEVICE
TAKE UP ROLLER WIDTH 16"(INCH) x 2
TAKE UP MOTOR 1HP AC MOTOR WITH INVERTER x 2
WINDING DEVICE
ROLLER EIDTH 16"(INCH) x 2
WINDING WIDTH 14"(INCH) x 2
WINDING MOYOR 750W x 2(SERVO MOTOR)
TOP